Cases, Foam and Accessories

All Boards, parts and supplies are now being sold by
Hagshouse Trailcam parts and supplies store
Any warranty or service questions contact Chris AKA 212 @ Hagshouse


Oversized Neoprene Sponge
Rubber Rope Seals for Pelican Cases




Eva Foam with adhesive backing

Cost: $3.00

Size -


Camera Flash Gaskets

To be used for flash seals and many other camera building uses also

4 ¼ “ by 3” with precise flash and shutter holes

Cost: $2.00




Assorted Wire Servo Connector

These are the Molex snap connectors, The male/sensor end has a 9 inch long assorted gauges of stranded servo wire. The female /camera end has 6 inch  assorted gauge wire. The wire is very soft and flexable  Makes as neat a finish as possible. Can be used for camera mods and externals, ect.

Cost: See below




Assorted Battery holders

Choose the battery holder(s) to meets your needs

Cost: See below




.9 Wide Angle Fresnel Lens

Wide Angle Fresnel Lens. Not as sensitive as the lodiff. The Bigfoot board was designed to be used with the lens. This lens helps greatly to better center animals walking by on a trail. Detects movement in a wider area out to 45 feet or more. Alignment of this lens is critical. Use the 1-inch standoffs with this lens

Cost: $2.50


.65 Lodiff Fresnel Lens

A sensitive long-range lens. Detects movement out to 100 feet or more, but in a narrower detection area. Use .75 standoffs with this lens.

Cost: $3.00


Flash Enhancer

Use over the flash hole to increase your camera’s flash distance by up to 50 percent.  I recommend using at least a 1-inch hole size to minimize creating a spotlight effect.

Cost: $3.00


Shutter and Flash Hole Glass

1.25x .16 Laser cut and thin enough to make it easy to recess the glass without taking too much material out of the case. 

Cost: $2.50


Mounting Standoffs with Screws 

Four 4/40 Standoffs and Screws. 

Use these to mount your Bigfoot board

Cost: $3.00




3/8 Mounting Standoffs with Screws 

Four 4/40 Standoffs and Screws. 

Use these to mount your Bigfoot board
to the correct distance with the
Snapshot Sniper Wide Angle Lens assembly

Cost: $2.50


Ratchet Rope

Quick pull 1/8 X 6' ratchet rope to quickly attach your camera

Includeds 6 foot Rope, S-Hook and Ratchet Hook

Cost: $5.00


PT 1100 Mounting Tape 1.5 inches by 2 feet

• Double  sided mounting tape.
• Use this for lens mounting.
• Replaces messy smelly glues.
• Completely waterproof seal.
• Is not conductive.
• Enough to complete several cams.

Cost: $3.00